Valor Senator 276N Specifikace

SenatorVent-free Room HeaterModel 276N - For Natural GasModel 276P - For LPG (Propane Gas)INSTALLATION ANDOPERATION MANUALPlease read this manua

10FOR YOUR SAFETY READ BEFORE LIGHTINGA. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow theseinstruct

11LIGHTING INSTRUCTIONS1. STOP! Read the safety information on previous page.2. Turn the control knob on right side of heater clockwise to “OFF” posit

12FLAME CHECKMake a visual check of the pilot and main burners periodically.Pilot flameThe pilot flame should always be alight when the heater is inop

133) Remove the two screws securing the upper corners of themesh guard (figure 15).4) slide the guard up and remove it from the heater.5) Remove d

14LIMITED WARRANTY POLICYValor warrants this appliance and all components for a period of three years from date of purchase against defects in materia

2LIST OF CONTENTSPageSafety Information...

3SAFETY INFORMATIONIMPORTANT: Please read and understand this manual before installing and operating your heater. Please keepthis manual for reference

4APPLIANCE SPECIFICATIONSFEATURE MODEL276N 276PGAS NATURAL PROPANEINLET PRESSURE MAX 10.5 14(Ins w.c.) MIN1511MANIFOLD PRESSURE MAX 4.2 9.7(In w.c.) M

5VENTINGThis heater shall not be installed in a confined space unlessprovisions are provided for adequate combustion and ventilationair.The National F

6UNPACKINGThe heater is supplied in two packs.Pack 1 Contains the cast-iron mantle fully assembled.Pack 2 Contains1 Heater unit fitted with elbow gas

7The valve is supplied in the open position. To shut the valve:1) Remove the screw cap and sealing washer by turningcounterclockwise2) Turn the slo

8FITTING CAST-IRON MANTLE1. Remove the two rectangular plates at back of the casting nearthe bottom (see figure 7). The plates and washers will not b

95. Swing the bottom of the mantle back. The mantleconnecting brackets should be outside the heater sides. Alignthe holes in the brackets with the th